...
Incoming plan review documents will undergo an inspection via our PDF Scout tool.
Pre-configured workflow distributions may be triggered.
The user may manually create plan review assignments.
Assignments will be created.
...
Prerequisites:
An open project record exists. See Add a Project record, Step 1.
Plan review documents in PDF format and supporting documents, in any file format, are accessible to the user.
...
Navigate to the Projects page and select the Documents tab.
Click the upload icon
on the bottom right of the Documents tab.Browse and select the PDF’s for plan review and supporting attachments (in other file formats).
Drag PDF’s not intended for plan review to the ‘Attachments Here’ panel, as shown below.
Supporting attachments will not be used to create plan review assignments. They are considered reference material only.
Click SELECT FILES to browse for documents or drag and drop files.
All files are listed in the “Plan” section by default.
Plans: Any files that are to be marked up during review are considered "Plans" and must be submitted in PDF format.
Keep these files listed under the Plans section.
Attachments: Any files that will not be marked up during review should be considered "Attachments." These files will be accessible to all plan reviewers as reference material in the EPR Review page.
Drag these files over to the Attachments section.
Confirm that the plans and supporting documents are
onlisted in the correct panels
.Select, then click the PROCESS button to launch
the PDF inspector for the incoming plan review files.
...
After the PDF inspection completes, results the PDF Scout inspector, which will check “Plan” files for the following:
Issue | Description | Result | Solution |
|---|---|---|---|
File Size | Documents must not exceed 400 MB. | REJECTION | Return to the source document and create PDF files that are below the file size limitation or break up PDF into smaller files. Follow the instructions in the DOCUMENT SUBMITTAL RECOMMENDATIONS as shown above. |
Paper Size | Checks for paper sizes smaller than 8.5" x 11" or larger than 36" x 48"and will trigger a warning if detected. | Warning | None required. These suggestions are in place because most printers cannot print wider than 36 inches. |
PDF Version | Checks PDF version. If PDF version older than 1.3 is detected, the file will be rejected. (Version 1.3 was released prior to 2001.) | REJECTION | Update the PDF to a newer version. |
Password protection | The inspector checks for password security that prevent opening the PDF. If the PDF cannot be opened, the file will be rejected. | REJECTION | Remove the password protection to allow PDF access. |
Page Access | The inspector tries to read each page in the document. If a page is not readable, the file will be rejected. | REJECTION | Adobe Reader may report these pages as damaged or in need of repair. Recreate the PDF from the source document using Adobe Pro or Nitro Pro. |
Annotations/SHX Text | Checks for annotations that appear in the pdf Reader ‘Comment’ panel, such as SHX Text generated by AutoCAD. | Warning | None required. Note that SHX text annotations will be removed from pdf 'Comment' panel when printing deliverable files so they do not interfere with review comments. (No other annotations will be removed.) |
Filename Special Characters | Checks if filename contains: &, #, $, +, [ or]characters. | REJECTION | Remove these characters from the filename and re-upload file. |
Page Orientation | Checks if document has mixed page orientations. | Warning | None required. Manually checking that pages are not upside down or sideways is recommended. |
The results of the PDF inspection are displayed on the REVIEW PROCESSED DOCUMENTS tab, shown below.
For files flagged with a warning icon or X status ,
Selectclick the eye icon to
seeview the inspection results and correct errors.
...
Delete plan review files marked with an X status
PDF's that do not pass inspection will not proceed to plan review and must be corrected.
Finishing upload for Plan Review files that pass inspection
...